Great Plains NTA3010 Predelivery Manual - Manual (Page 25)

Great Plains Manufacturing, Inc. Setup 23
11/06/2008 160-220M
Install Transport Locks
Only the center section has transport lock, as the wings
are folded for transport.
Refer to Figure 24
32. Install transport locks (two) on rockshaft. Remove
the locks from the storage plate on the center sec-
tion. Pin them between the frame and rockshaft
lugs
.
Refer to Figure 25
33. Remove lift-assist transport locks from storage loca-
tions on weldment forward of parallel arms.
Refer to Figure 26
34. Pin the locks on the extended lift-assist cylinder
rods.
35. If this is the first time the drill has been raised,
remove the shipping stands. Make sure transport
locks are in place before removing shipping stands.
!
WARNING
You may be severely injured or killed by being crushed from a
falling implement. Always have transport locks in place and
frame sufficiently blocked up when working on implement.
Figure 24
Rockshaft Lock Channel
16165
1
2
1
2
Figure 25
Lift-Assist Lock Storage
16248
3
3
Figure 26
Lift-Assist Lock Engaged
16167
4
4