Great Plains NP4000B Operator Manual - Manual (Page 187)

Great Plains Manufacturing, Inc. Table of Contents Index Appendix C - Accessory Installation 183
2014-05-14 Table of Contents Index 417-199M
Transfer Liquid Coulter
This applies only to kit 407-907A and three-coulter
configurations. For single-coulter configurations,
continue at “Install Liquid Coulter” below.
Refer to Figure 105
20. Attach the hoist line to the loop at the top of the
quick-attach casting .
21. At the casting bottom, remove and save two sets:
803-021C NUT HEX 5/8-11 PLT
804-022C WASHER LOCK SPRING 5/8 PLT
802-053C HHCS 5/8-11X1 3/4 GR5
804-095C WASHER FLAT 5/8 HARD ASTMF436
22. Use the hoist to remove the coulter assembly. Set
one assembly (with a straight shank) aside for use as
the side dress coulter.
23. Leave quick-attach mounts in place.
24. Move the selected coulter to the quick-attach coulter
mount on the side dress wing extension. It may be
necessary to rotate the coulter shank 180
° in the
quick-attach weldment.
Continue at “Close-Out Side Dress Liquid Coulter”
below.
Install Liquid Coulter
This applies to kit 407-940A or 407-941A and single- or
2-coulter configurations. For 3-coulter configurations,
see “Transfer Liquid Coulter” on page 183.
Refer to Figure 106
25. Select one each new:
149-584D COULTER CLAMP 6H X 4W
204-691K NP COULTER ASSY RH
two new:
806-016C U-BOLT 5/8-11 X 6 1/32 X 5 3/4
and four sets new:
804-022C WASHER LOCK SPRING 5/8 PLT
803-021C NUT HEX 5/8-11 PLT
26. Align the coulter shank and clamp at the
position marked at step 12 on page 181. Loosely
secure with U-bolts
, lock washers and nuts .
27. Adjust the coulter height to match the rest of the
applicator. Secure the clamp nuts.
Close-Out Side Dress Liquid Coulter
28. Connect the grease bank and fertilizer delivery
tubing previously on the left-most rear row.
29. Skip to “Shift 2-Point Hitch” on page 186.
30. Note change in swath for rate calculations.
Figure 105
Rear Coulter Mounts
34974
21
34 41
35
43
21
34
41
35
43
Possible Agricultural Chemical Hazard:
Wear chemical gloves while handling disconnected drop lines.
Hose may contain residual amounts of chemical fluids. Consult
the Material Safety Data Sheet (MSDS) for the material most
recently applied.
Figure 106
Install Single-Coulter Side Dress
34980
12
15
44
34
41
14
12
15
44
41
34
14 12
44 41 34