Bio-Rad Experion DNA Analysis Kits - Manual (Page 34)

30 Technical Support: 1-800-4BIORAD • 1-800-424-6723 • www.bio-rad.com
Appendix A: Safety Notices
General Use Information
Always connect the Experion
™ automated electrophoresis station, priming station, and vortex station to
a grounded AC outlet rated 10 A/100–240 V using the AC power cord provided.
Never remove the outer casing of the electrophoresis station or other system components. Doing so
voids the manufacturer warranty. The only user-serviceable part of the Experion system is the priming
seal gasket of the priming station. If you suspect other parts need service, call your local Bio-Rad office.
The electrophoresis station is intended for laboratory use only . Do not use the equipment except
as intended.
Do not operate the Experion system in extreme humidity (>90%) or where condensation can short the
internal electrical circuitry.
Periodically inspect Experion electrophoresis stations for obvious damage that might affect normal
operation.
Do not operate after the equipment malfunctions or if it has been damaged in any manner.
Return the electrophoresis station to Bio-Rad for service or examination, repair, or electrical or
mechanical adjustment.
When using electrical equipment, basic safety precautions should always be followed to reduce the
risk of fire, electric shock, and personal injury. To reduce the risk of electric shock, do not immerse the
electrophoresis, priming, or vortex station in water or other liquid.
Electrophoresis Station Safety Notice
The Bio-Rad Experion electrophoresis station is designed and certified to meet EN 61010-1 and IEC
61010-1 safety standards. EN 61010-1- and IEC 61010-1-certified products are safe to use when
operated in accordance with the instruction manual. This equipment should not be modified in any way.
Alteration of these electrophoresis stations will:
n
Void the manufacturer’s warranty
n
Void the EN 61010-1 and IEC 61010-1 safety certification
n
Create a potential safety hazard
Bio-Rad Laboratories is not responsible for any injury or damage caused by the use of this system
for purposes other than those for which it is intended, or by modifications of the components not
performed by Bio-Rad Laboratories or an authorized agent.
These products conform to the “Class A” standards for electromagnetic emissions intended for
laboratory equipment applications. It is possible that emissions from these products may interfere with
some sensitive appliances when placed nearby or in the same circuit as those appliances. The user
should be aware of this potential and take appropriate measures to avoid interference.
The vortex station is built in accordance with electrical requirements for measurement, control, and
laboratory by IEC 61010-1; UL 61010-1 (U.S.), CAN/CSA C22.2 No. 61010-1 (Canada), Régles de
sécurité pour appareils électriques de mesurage, de régulation, et de laboratoire; Partie 1: Prescriptions
générales (CEI 1010-1, France), DIN EN 61010-1 class VDE 0411 (Germany).
Experion Automated Electrophoresis System