Bio-Rad Nuvia™ S Media - Manual (Page 12)

8
4. Connect the inlet of the cartridge to the
male luer fitting on the MV-6 sample inject
valve (Figure 2). If not using the MV-6
sample inject valve, connect a barb to
male luer fitting on the 1.6 mm ID tubing,
then connect to the top of the female
luer on the Bio-Scale Mini cartridge. For
optimum performance, mount the cartridge
vertically, with the arrow on the cartridge
pointing down.
5. Connect the outlet to the 1.6 mm ID tubing
leading to the BioLogic LP optics module
or Econo UV monitor. Use the shortest
length (approximately 10 cm) of 1.6 mm ID
tubing. Connect a barb to female luer to
the 1.6 mm ID tubing, then connect to the
bottom of the male luer on the Bio-Scale
Mini cartridge.