John Deere stx38 - Manual (Page 159)

3/21/97
4 - 75
ELECTRICAL REPAIR
REMOVE AND INSTALL STARTER
SOLENOID
NOTE: Relay in located at the right-hand front corner
of battery compartment.
1. Remove battery.
2. Disconnect all wires and remove solenoid.
NOTE: When installing connectors to solenoid, make
sure both barrel terminals (A) are pushed all-
the-way on so they stay locked onto their stud.
3. Assemble in reverse order of disassembly.
REMOVE AND INSTALL STATOR
AND IGNITION MODULE
1. Turn flywheel magnet (B) away from ignition
module (A).
2. Disconnect wire (D) from terminal.
3. Remove cap screws (C) and ignition module.
4. Remove flywheel (see Remove and Install Flywheel
in Engine Repair group).
5. Remove two white stator wires from connector (F).
6. Remove clamps (G).
7. Remove cap screws and stator (E).
8. Inspect for damage.
9. Thread stator wires through hole in crankcase and
install in connector. Fasten clamps.
10. Install stator. Tighten cap screws to specification.
11. Install flywheel and tighten cap screw to
specification (see Remove and Install Flywheel in
Engine Repair section).
12. Rotate magnet away from module mount. Install
module loosely.
13. Align flywheel magnet (B) with mounting posts for
ignition module.
14. Place 0.25 mm (0.01 in.) feeler gauge blade (K) or
shim stock across magnet face.
IMPORTANT: BE SURE flywheel magnet (B) is
centered on ignition module (A) so all three
polls of the ignition module are properly gapped
from the flywheel magnet.
15. Position ignition module (A) so all three polls mate
with feeler gauge blade (K) and its two mounting
holes align with mounting posts.
Continued on next page
M55914
A
D
B
A
C
M58359
E
F
G
M58361
F
G
H
I
J
E
B
K
D
C
M58360
A