Casio XJ-350 - Manual (Page 113)

113
Troubleshooting
The projector does not
project any image from the
connected device. The connected computer or video device may not
be turned on, or it may not be outputting a video
signal.
J Make sure the connected computer or video
device is turned on, and perform the required
operation on it to output a video signal.
—
The correct output source is not selected on the
projector.
J On the projector, select the input source that
corresponds to the device whose image you
are trying to project.
45
The projector does not
correctly project the image
from the connected device. Images may not project correctly when you have
the component output of a video device
connected to the RGB input terminal of the
projector.
J Try using the projector’s VIDEO input terminal
or S-VIDEO input terminal.
36
When RGB/Component is
selected as the input
source, the color of the
projected image or the
image itself is abnormal. The settings configured on the setup menu’s
“Input Settings
J RGB Input” menu may not be
compatible with the device connected to the RGB
input terminal.
J Use the setup menu to configure the “Input
Settings
J RGB Input” menu settings to correct
the problem.
85
The projector keys to not
work. Key lock may be turned on.
J Turn off key lock. 91
The remote controller does
not work. The remote controller batteries may be dead.
J Replace the batteries. 25
The remote controller may be too far from the
projector.
J Make sure the remote controller is within the
allowable range when you operate it.
27
The TEMP or LAMP
indicator is flashing or lit. J See “Error Indicators”. 111
The message “It is time to
replace the lamp.” is being
projected. It is time to replace the lamp.
J Replace the lamp. 102
The message “The lamp
has exceeded its service
life!.” is being projected. The allowable life for the lamp has been
exceeded, and the projector will not turn on.
J Replace the lamp. 102
Problem Cause and Recommended Action See page