Casio XJ-350 - Manual (Page 28)

Getting Ready
28
Getting Ready This section explains how to set up the projector to get it ready for use, and how to connect
it to an input source (computer or video device).
It also includes information about how to turn on the projector, how to select the display
language the first time you turn it on, and precautions you need to keep in mind concerning
the power supply.
This projector is designed for tabletop use only. Place the projector onto a table, desk, or
stand that is level and firm, making sure you allow enough room around it.
z The following illustrations show how the projector should be oriented for optimum
projection relative to the screen.
z You can place the projector on a surface that is angled up to 30 degrees up or down
during use.Angling the projector more than 30 degrees up or down can cause rupture or
premature aging of the projector's lamp,or malfunction of the projector.
z The above setup enables proper projection without any image correction. If the projector
is at an angle to the screen, a phenomenon called “keystoning” will occur, which causes
the sides, and/or the top and bottom of the image to be different lengths. The projector
comes with a keystone correction feature that automatically corrects the image. See
“Keystone Correction (KEYSTONE)” on page 50 for information about keystone correction.
Setting Up the Projector
Viewed from Above Viewed from the Side
Screen
Screen
The center of the projector’s lens
should be aligned with the horizontal
center of the screen. Make sure the projector is at a right
angle to the screen.