Casio XJ-350 - Manual (Page 41)

41
Getting Ready
z When you turn off the projector, the lamp goes out and the projector goes into a cool
down state. Note that you will not be able to turn the projector back on again while it is
cooling down.
z The projector may remain quite hot for a while after you turn it off. Avoid touching the
projector after you turn it off.
z Note that the projector may still be quite warm even after it completes its cool down
procedure. Before packing up the projector, it is recommended that you check to make
sure that the fan is stopped and that the projector is no longer warm.
To turn off the projector
1.
Press the [ ] (power) key.
z This causes a confirmation message like the one shown below to appear in the center
of the projection screen.
z If you do not turn off the projector the confirmation message will disappear
automatically after about 10 seconds. The confirmation message will also disappear if
you press [ESC] key.
2.
To turn off the projector, press the [ ] (power) key again in response
to the confirmation message.
z This causes the projector lamp to go out and stops projection.
z Also the POWER/STANDBY indicator starts to flash amber, which indicates that the
projector is cooling down. It takes about 90 seconds from the start of cool down until
the projector turns off.
z The projector will not turn back on again while it is cooling down.
z After cool down is finished, the POWER/STANDBY indicator on the top of the projector
will light amber, which indicates the standby state. You can now turn the projector back
on, if you want.
Turning Off the Projector