Canon VK-64 - Manual (Page 115)

115
4
Registering
Camera
Ser
ver
and
S
etting
Recor
ding
Sc
hedule
Changing the Camera Server Settings
●
Preset
Presets must be set on the Camera Server in advance. You cannot set them with the
VK-64/VK-16.
If the recording settings using a preset are used on the Camera Server, the preset
position will override camera positions set by VK-64/VK-16, including those in recording
schedules and Camera Server position. If VK-64/VK-16 has camera control, this will be
lost when the Camera Server is setting a new preset position.
If predefined presets are not shown in the Preset drop-down menu even if they have
been defined on the Camera Server, click Camera Control to display the Camera
Control Panel, obtain camera control, then configure the settings again.
●
Restrict Service Time
If a Camera Server has been configured with Restrict Service Time, VK-64/VK-16 will
not be able to record from the Camera Server during restricted times.
●
External Device
Specify the name of the external device, such as sensor name. You cannot set it with
the VK-64/VK-16.
If the external device is not set on the Camera Server, the VK-64/VK-16 cannot set it.
●
Sensor Input, Recording to Camera Memory
Camera Servers have certain features to capture image into its memory based on
sensor input or schedule. If settings are enabled on the Camera Server, they take
precedence over any settings made in VK-64/VK-16. This may cause some confusion if
your VK-64/VK-16 recording schedules fail to record with the correct camera preset. You
should disable such Camera Server features if you wish VK-64/VK-16 settings to take
precedence.