Canon VK-64 - Manual (Page 222)

222
Restore Procedure
Restoring Data from Backup for Data Protection
The following explains how to reconstruct the Storage Server for the VK-64/VK-16 for
maintenance or recovery from a failure.
Check that the PC hardware environment has been restored to the former state.
Be sure to use the same folder organization as before.
Install the VK-64/VK-16.
After installation completes, stop the Storage Server from the Storage Server
Configuration window.
Restore the VK-64/VK-16’s configuration file to the former location.
The default location is as follows:
<System Drive>: \Documents and Settings\All Users\Application Data\Canon\
WebView\NVR\
Restore the recorded video data file to the former location.
The default location is as follows:
<Save video in>: \WebView-NVR\videofiles
Restore the event data file to the former location.
The default location is as follows:
<Save video in>: \WebView-NVR\eventfiles
Start the Storage Server from the Storage Server Configuration window.
Check that the recording operation is performed correctly. Also check that restored
video data is played back correctly.
8
7
6
5
4
3
2
1
If the Maximum retained history setting is used in the Storage
Server Configuration window and the restored video data
contains data exceeding the retaining period, that data will be
deleted when the Storage Server starts.
Note