Display, Display assembly, Removing the display assembly – Dell Studio 1440 (Mid 2009) User Manual
Page 17
Back to Contents Page
Display
Dell™ Studio 14z Service Manual
Display Assembly
Removing the Display Assembly
1.
Follow the instructions in
Before You Begin
.
2.
Remove the battery (see
Removing the Battery
).
3.
Remove the keyboard (see
Removing the Keyboard
).
4.
Remove the hard drive (see
Removing the Hard Drive
).
5.
Remove the palm rest (see
Removing the Palm Rest
).
6.
Make note of the cable routing and carefully dislodge the Mini-Card antenna cables from their routing guides.
7.
Disconnect the Mini-Card cables from the Mini-Cards, if applicable (see
Wireless Mini-Cards
).
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To help prevent damage to the system board, you must remove the battery from the battery bay before you begin working inside the
computer.
1
power button cable connector
2
mylar sleeves (2)
3
antenna cables (2)