I/o board, Removing the i/o board, Replacing the i/o board – Dell Studio 1440 (Mid 2009) User Manual
Page 29
Back to Contents Page
I/O Board
Dell™ Studio 14z Service Manual
Removing the I/O Board
1.
Follow the procedures in
Before You Begin
.
2.
Remove the battery (see
Removing the Battery
).
3.
Remove the system board (see
Removing the System Board
).
4.
Remove the two screws that secure the I/O board to the computer base.
5.
Lift the I/O board at an angle toward the side of the computer and out of the computer base.
Replacing the I/O Board
1.
Follow the procedures in
Before You Begin
.
2.
Place the I/O board on the computer base.
3.
Replace the two screws that secure the I/O board to the computer base.
4.
Replace the system board (see
Replacing the System Board
).
5.
Replace the battery (see
Replacing the Battery
).
Back to Contents Page
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
1
screws (2)
2
I/O board