Camera, Removing the camera, Replacing the camera – Dell Studio 1440 (Mid 2009) User Manual
Page 9
Back to Contents Page
Camera
Dell™ Studio 14z Service Manual
Removing the Camera
1.
Follow the instructions in
Before You Begin
.
2.
Remove the battery (see
Removing the Battery
).
3.
Remove the keyboard (see
Removing the Keyboard
).
4.
Remove the hard drive (see
Removing the Hard Drive
).
5.
Remove the palm rest (see
Removing the Palm Rest
).
6.
Remove the display assembly (see
Removing the Display Assembly
).
7.
Remove the display bezel (see
Removing the Display Bezel
).
8.
Remove the display panel (see
Removing the Display Panel
).
9.
Disconnect the camera cable from the connector on the camera board.
10.
Remove the two screws securing the camera board.
11.
Remove the camera board.
Replacing the Camera
1.
Follow the instructions in
Before You Begin
.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
1
screws (2)
2
camera
3
camera cable