Speakers, Removing the speakers, Replacing the speakers – Dell Studio 1440 (Mid 2009) User Manual
Page 46
Back to Contents Page
Speakers
Dell™ Studio 14z Service Manual
Removing the Speakers
1.
Follow the instructions in
Before You Begin
.
2.
Remove the battery (see
Removing the Battery
).
3.
Remove the keyboard (see
Removing the Keyboard
).
4.
Remove the hard drive (see
Removing the Hard Drive
).
5.
Remove the palm rest (see
Removing the Palm Rest
).
6.
Remove the four screws (two on each speaker) that secure the speakers to the computer base.
7.
Make note of the speaker cable routing.
8.
Disconnect the speaker cable from its connector on the system board.
9.
Lift the speakers off the computer base.
Replacing the Speakers
1.
Follow the procedures in
Before You Begin
.
2.
Replace the speakers on the computer base and route the speaker cables along the routing guides.
3.
Connect the speaker cable to its connector on the system board.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
1
screws (4)
2
speakers (2)
3
speaker cable