Display bezel, Replacing the display assembly, Removing the display bezel – Dell Studio 1440 (Mid 2009) User Manual
Page 18
8.
Disconnect the power button cable from the connector on the system board.
9.
Remove the four screws (two on each side) of the display assembly.
10.
Lift the display assembly off the computer.
Replacing the Display Assembly
1.
Follow the instructions in
Before You Begin
.
2.
Place the display assembly in position and replace the four screws (two on each side) of the display assembly.
3.
Connect the power button cable to the connector on the system board.
4.
Route the Mini-Card antenna cables through the routing guides and if applicable, connect the cable connectors to the Mini-Cards on the system board.
5.
Replace the palm rest (see
Replacing the Palm Rest
).
6.
Replace the hard drive (see
Replacing the Hard Drive
).
7.
Replace the keyboard (see
Replacing the Keyboard
).
8.
Replace the battery (see
Replacing the Battery
).
Display Bezel
Removing the Display Bezel
1.
Remove the display assembly (see
).
1
screws (4)
2
power button cable
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
CAUTION:
The display bezel is extremely fragile. Be careful when removing it to prevent damaging the bezel.