Palm rest, Removing the palm rest – Dell Studio 1440 (Mid 2009) User Manual
Page 40
Back to Contents Page
Palm Rest
Dell™ Studio 14z Service Manual
Removing the Palm Rest
1.
Follow the instructions in
Before You Begin
.
2.
Remove any installed cards from the ExpressCard slot or the 8-in-1 Media Card Reader.
3.
Remove the battery (see
Removing the Battery
).
4.
Remove the keyboard (see
Removing the Keyboard
).
5.
Remove the hard drive (see
Removing the Hard Drive
).
6.
Disconnect the camera cable from the connector on the system board, and pull the display cable pull-tab to disconnect the display cable from the
connector on the system board.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To help prevent damage to the system board, you must remove the battery from the battery bay before you begin working inside the
computer.
CAUTION:
Pull on the plastic tab on top of the connectors to avoid damaging the connectors.
1
camera cable
2
display cable