Communication cards, Subscriber identity module, Wireless mini-cards – Dell Studio 1440 (Mid 2009) User Manual
Page 36: Installing the sim, Removing the sim
Back to Contents Page
Communication Cards
Dell™ Studio 14z Service Manual
Subscriber Identity Module
Subscriber Identity Modules (SIM) identify users uniquely through an International Mobile Subscriber Identity.
Installing the SIM
1.
Follow the procedures in
Before You Begin
.
2.
Remove the battery (see
Removing the Battery
).
3.
In the battery bay, slide the SIM into the SIM compartment.
Removing the SIM
1.
Follow the procedures in
Before You Begin
.
2.
Press the SIM into the SIM compartment to release it.
3.
When it is partially ejected, remove the SIM from the battery bay.
4.
Replace the battery (see
Replacing the Battery
).
Wireless Mini-Cards
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE:
Only GSM HSDPA type cards need a SIM. EVDO cards do not use a SIM.
1
battery bay
2
SIM
3
SIM compartment
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
To help prevent damage to the system board, you must remove the battery from the battery bay before you begin working inside the
computer.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.