Dell PowerVault DL2200 - Manual (Page 155)

Jumpers and Connectors
155
NOTE:
If you assign a new system and/or setup password with the jumper
plug still in the "disabled" position, the system disables the new password(s)
the next time it boots.
6 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
7 Open the system. See "Opening the System" on page 64.
8 Move the password jumper back to the enabled position to restore the
password function. See Table 6-1.
9 Close the system. See "Closing the System" on page 65.
10 Reconnect your system and peripherals to their electrical outlets, and turn
on the system.
11 Assign a new system and/or setup password.
To assign a new password using the System Setup program, see "System
and Setup Password Features" on page 53.
book.book Page 155 Wednesday, May 12, 2010 9:26 PM