Dell PowerVault DL2200 - Manual (Page 33)

About Your System
33
Unable to launch
System Services
image. System
halted!
System halted after F10
keystroke because System
Services image is either
corrupted in the system
firmware or has been lost due
to system board replacement.
The optional iDRAC6
Enterprise card flash memory
or BMC SPI flash may be
corrupted.
Restart the system and
update the Lifecycle
Controller repository to the
latest software to restore full
functionality. See the
Lifecycle Controller User
Guide for more information.
Restore the flash memory
using the latest version on
support.dell.com. See the
Integrated Dell™ Remote
Access Controller 6
(iDRAC6) User Guide for
instructions on performing a
field replacement of the
flash memory.
Unexpected
interrupt in
protected mode.
Improperly seated memory
modules or faulty
keyboard/mouse
controller chip. Reseat the memory modules.
See "Troubleshooting
System Memory" on
page 137. If the problem
persists, see "Getting Help"
on page 157.
Unsupported CPU
combination
Unsupported CPU
stepping
detected.
Processor(s) is not supported
by the system. Install a supported processor
or processor combination.
See "Processors" on
page 103.
Unsupported DIMM
detected. The
following DIMM
has been
disabled: x
Invalid memory
configuration. The system
runs but with the specified
memory module disabled. Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines" on
page 81.
Message Causes Corrective Actions
book.book Page 33 Wednesday, May 12, 2010 9:26 PM