Dell PowerVault DL2200 - Manual (Page 86)

86
Installing System Components
Figure 3-12. Removing and Installing a Memory Module
7 Align the memory module's edge connector with the alignment key of the
memory module socket, and insert the memory module in the socket.
NOTE:
The memory module socket has an alignment key that allows you to
install the memory module in the socket in only one way.
8 Press down on the memory module with your thumbs to lock the memory
module into the socket.
When the memory module is properly seated in the socket, the ejectors on
the memory module socket snap in place.
9 Repeat step 5 through step 8 of this procedure to install the remaining
memory modules. See Table 2.
10 Replace the cooling shroud. See "Installing the Cooling Shroud" on
page 67.
11 Close the system. See "Closing the System" on page 65.
1 memory module 2 memory module socket ejectors (2)
3 alignment key
2
1
3
book.book Page 86 Wednesday, May 12, 2010 9:26 PM