Dell PowerVault DL2200 - Manual (Page 30)

30
About Your System
Read fault
Requested sector
not found.
The operating system cannot
read from the hard drive or
USB device, the system could
not find a particular sector on
the disk, or the requested
sector is defective. Replace the USB medium
and device. Ensure that the
USB cables and SAS/SATA
backplane cables are properly
connected.
See "Troubleshooting a USB
Device" on page 130 or
"Troubleshooting a Hard
Drive" on page 139 for the
appropriate drive(s) installed
in your system.
SATA Port x
device not
found.
There is no device connected
to the specified SATA port. Information only.
Sector not found.
Seek error.
Seek operation
failed.
Faulty hard drive, USB
device, or USB medium. Replace the USB medium or
device. Ensure that the USB
or SAS backplane cables are
properly connected. See
"Troubleshooting a USB
Device" on page 130 or
"Troubleshooting a Hard
Drive" on page 139 for the
appropriate drive(s) installed
in your system.
Shutdown
failure.
General system error. See "Getting Help" on
page 157.
Sparing mode
disabled. For
sparing mode,
matched sets
of three must
be populated
across slots.
The memory configuration
does not match the setting
in BIOS. The BIOS setting
has been disabled. Reconfigure the memory
modules for Memory
Sparing mode. See "System
Memory" on page 80.
Message Causes Corrective Actions
book.book Page 30 Wednesday, May 12, 2010 9:26 PM