Dell PowerVault DL2200 - Manual (Page 34)

34
About Your System
Unsupported
memory
configuration.
DIMM mismatch
across slots
detected:
x , x , ...
Invalid memory
configuration.
Memory modules are
mismatched in the
specified slots. Ensure that the memory
modules are installed in a
valid configuration.
See "General Memory
Module
Installation Guidelines" on
page 81.
Unused memory
detected. DIMM’s
installed in the
following slot
are not available
when in mirror
mode: x , x , x.
The memory configuration
is not optimal for
mirroring mode.
Modules in the
specified slots are unused. Reconfigure the memory for
memory mirroring mode, or
change the memory mode to
Optimized or Sparing in the
BIOS setup screen. See
"System Memory" on
page 80.
Unused memory
detected. DIMM’s
installed in the
following slot
are not available
when in 128-bit
advanced ECC
mode: x , x , x.
The memory configuration is
not optimal for Advanced
ECC Memory Mode.
Modules in the specified
slots are unused. Reconfigure the memory for
Advanced ECC Memory
Mode, or change the
memory mode to Optimized
or Sparing in the BIOS setup
screen. See "System
Memory" on page 80.
Warning: A fatal
error has caused
system reset!
Please check the
system event log!
A fatal system error
occurred and caused the
system to reboot. Check the SEL for
information that was logged
during the error. See the
applicable troubleshooting
section in "Troubleshooting
Your System" on page 129 for
any faulty components
specified in the SEL.
Warning! No micro
code update
loaded for
processor n.
Micro code update failed. Update the BIOS firmware.
See "Getting Help" on
page 157.
Message Causes Corrective Actions
book.book Page 34 Wednesday, May 12, 2010 9:26 PM