Dell PERC 4/SI - Manual (Page 59)

1. At the root prompt, perform the following steps:
a. For NetWare 5.1 and 6.0, type:
nwconfig
and press <Enter>.
The Installation Options screen displays.
b. For NetWare 6.5, type:
hdetect
and press Continue on the first menu to go to the storage drivers, then follow the instructions for updating the driver. For NetWare 6.5, you can
press <F3> to auto detect drivers.
2. Select Configure Disk and Storage Device Options, then press <Enter>.
3. Select one of the options that display:
l Discover and load an additional driver.
If you select the option Discover and load an additional driver, the system detects the extra unit. Perform step 4 to complete the procedure.
4. At the prompt to select a driver from the list, press <Insert> to insert the driver, which completes the procedure.
If you select the option Select an additional driver, perform steps 5 - 8.
5. After you select Select an additional driver, the Select a Driver screen displays.
6. Press <Insert> and read the instructions that display.
7. Put the driver diskette in the diskette drive and press <Enter>.
8. The system then detects a driver and installs it.
Modifying the PCI Slot Numbers for the Controllers
Perform the following steps to modify the PCI slot numbers for the controller:
1. At the command prompt, type:
C:\NWSERVER>
and press <Enter>.
2. Type
server –nss
(Not load Storage Service /modules.NLM)
3. At : Prompt (System Console), type:
load pedge3.ham