Updating an existing driver for netware 5.1 or 6.0 – Dell PERC 4/SI User Manual

Page 61

Advertising
background image

10.

 

Select Continue and press <Enter>.

 

 

Updating an Existing Driver for NetWare 5.1 or 6.0

 

Perform the following steps to update an existing driver for NetWare 5.1 or 6.0:

1.

 

Create a driver diskette.

 

See

Creating a Driver Diskette

in the

Installing Windows 2000 or 2003 Using the Microsoft Operating System CD with Driver Diskette

section for

information. (The procedure for creating a driver diskette is the same for all operating systems.)

2.

 

Once the NetWare server is up, type the following:

 

nwconfig

3.

 

Press <Enter> to access the NetWare Configuration Utility.

4.

 

On the Configuration Options screen, select Driver Options and press <Enter>.

5.

 

Under the Driver Options, select Configure Disk and Storage Options, then press <Enter>.

6.

 

Under the Additional Driver Actions menu, press the down arrow key to select the Additional Driver option, then press <Enter>.

7.

 

Press <Insert> to install an unlisted driver.

8.

 

Press <Insert> again if using a diskette; otherwise, press <F3> to specify a different location.

9.

 

Insert the driver diskette into the diskette drive and press <Enter>.

 

The file pedge3.ham displays under the option Select a Driver to Install.

10.

 

Highlight pedge3.ham and press <Enter>.

11.

 

Select Yes to copy pedge3.ham files to C:\NWSERVER.

12.

 

Select No to save the existing file messages to C:\NWSERVER.

13.

 

Under pedge3 Parameters, perform the following steps to provide the slot number.

14.

 

Press <Alt><Esc> to access System Console.

15.

 

On the System Console, type:

 

load pedge3

16.

 

Press <Enter>.

 

The following supported slot options display:

l

 

No Selection

l

 

PCI Slot_2.1 (HIN 203)

17.

 

Write down the number after "HIN".

 

In the example in

step 16

, it is 203.

18.

 

Under Choice, type:

 

0

 

for the option No Selection.

19.

 

Unload pedge3.ham.

20.

 

Press <Alt><Esc> until you exit the System Console and return to the pedge3 Parameters screen in the NetWare Configuration Utility.

NOTE:

You must load a driver for each controller. For example, if you have four adapters, the driver is listed four times.

Advertising
This manual is related to the following products: