Dell PERC 4/SI - Manual (Page 62)

21. Under Slot Number, enter the slot number you obtained from System Console and press <Enter>.
22. Press <F10> to save the pedge3 parameters.
23. Under Driver pedge3 Parameters Actions, select Save Parameters and Load Driver, and press <Enter>.
24. Select No when asked to load additional drivers.
pedge3 will be listed on the Selected Disk Driver screen.
25. Exit the NetWare Installation Utility.
26. From server console, type:
reset server
to restart the server for the changes to take effect.
Updating an Existing Driver for NetWare 6.5
Perform the following steps to update an existing driver for NetWare 6.5:
1. Create a driver diskette.
See Creating a Driver Diskette in the Installing Windows 2000 or 2003 Using the Microsoft Operating System CD with Driver Diskette section for
information.
2. Once NetWare begins to boot, the following message displays: Press ESC to abort OS boot.
3. Press <Esc>.
4. At the command prompt, type:
C:\NWSERVER>
and press <Enter>.
5. At C:\NWSERVER>, insert a driver diskette into the floppy drive.
6. Type:
cd A:\
and press <Enter>.
7. At the A:\ prompt, type:
copy A:\*.* C:\NWSERVER\DRIVERS
and wait for the copy action to complete.
8. Change the directory and type:
cd C:
The path displays as "C:\NWSERVER".
9. At C:\NWSERVER prompt, type: