Dell PERC 4/SI - Manual (Page 60)

and press <Enter>.
The following supported slot options display:
l No Selection
l PCI Slot_2.1 (HIN 202)
l PCI EMBEDDED (HIN 10017)
4. Under choice, type:
0
This is for no selection.
5. At the command prompt (System Console), type
Edit Startup.ncf
A list of CDM drivers displays.
6. Select LOAD PEDGE3.HAM SLOT=XXXX.
7. Before you exit the list of CDM drivers, press <Alt> <V> to save the update.
8. Press <Alt> <X> to exit to C:\NWSERVER.
9. At the C:\NWSERVER prompt, type the following for the operating system to boot:
server
The operating system boots.
Performing a Standard Mode Installation of NetWare 5.1SBE, 6.0, and 6.5
Standard mode means that you accept the defaults for the components to be installed. Perform the following steps for a standard mode installation on
NetWare 5.1SBE, 6.0, and 6.5:
1. At Server Settings, select Continue and press <Enter> to accept the default.
2. At Regional Settings, select Continue and press <Enter> to accept the default.
3. At Mouse type and Video mode select Continue and press <Enter> to accept the default.
The system will take several minutes to load files. It will find the device drivers that support the adapter.
4. Insert the driver diskette in the floppy (A:/) drive.
5. For device types and driver names, select Modify and press <Enter>.
6. Highlight Storage Adapters and press <Enter>.
7. At the option Add, Edit or Delete Storage Drivers, press <Insert> to add a driver.
8. At the option Select a Driver for each Storage Adapter, press <Insert> to add an unlisted driver.
The system scans the path for the A:/ drive. The driver diskette is already in the A:/ drive. The option Return to Driver Summary displays.
9. Select Return to Driver Summary and press <Enter>.
NOTE: Write down the number after "HIN". In step 3, the number is 10017.