Dell 5330dn Workgroup Mono Laser Printer - Manual (Page 78)

If necessary, expand the paper output extension to prevent print media from falling off the output tray.
Standard bin 250 sheets of 75 g/m 2
plain paper
Plain paper up to 163
g/m
2 , Envelopes (Short -
edge Feed Only), Labels.
N/A - One is standard on
the printer and located on
the top of the printer.
Output expander-bin 1 600 sheets of 75 g/m 2
paper
Plain paper up to 163
g/m
2
1
For information on
installing an output
expander, see
"Installing
an Output Expander."
NOTE: For printing to the Standard bin, Output Expander and Duplexer, close the rear output tray. Use the rear output tray only for special media, such
as like envelope, labels and transparencies.
Printing to the Rear Door (face up)
When using the rear door, paper comes out of the printer face up.
Printing from the Multi-purpose Feeder to the rear door provides a straight paper path. Using the rear door might improve the output quality with special
materials.
To use the rear door:
Open the rear door by pulling it down.
CAUTION: The fuser area inside the rear door of your printer becomes very hot when in use. Use caution when accessing this area.
Printing to the Optional Output Expander (face down)
You can increase the paper output capacity of your printer by installing an Output Expander. An Output Expander holds 600 sheets of plain paper. See
"Installing an Output Expander." for installation instructions.
NOTE: Paper with a smaller size of width of 3"(76.2mm) and length of 5.82"(148.5mm) cannot be print out in the ouput expander.