Dell 1135n Multifunction Mono Laser Printer - Manual (Page 4)

This could result in electric shock or fire and/or injury to
your pet.
If the machine has been dropped, or if the cabinet
appears damaged, unplug the machine from all
interface connections and request assistance from
qualified service personnel.
Otherwise, this could result in electric shock or fire.
If the machine does not operate properly after these
instructions have been followed, unplug the machine from
all interface connections and request assistance from
qualified service personnel.
Otherwise, this could result in electric shock or fire.
If the machine exhibits a sudden and distinct
change in performance, unplug the machine from all
interface connections and request assistance from
qualified service personnel.
Otherwise, this could result in electric shock or fire.
Operating method
Caution
Do not forcefully pull the paper
out during printing.
It can cause damage to the
machine. When printing large quantities, the bottom part of the
paper output area may get hot. Do not allow children to
touch.
Children may be burned.
Be careful not to put your hand
between the machine and paper
tray.
You may get injured. When removing jammed paper, do not use tweezers or
sharp metal objects.
It can cause damage to the machine.
Do not block or push objects into the
ventilation opening.
This could result in elevated component
temperatures which can cause damage or
fire.
Do not allow too many papers to stack up in the paper output
tray.
It could cause damage to the machine.
Use care to avoid paper cuts when
replacing paper or removing jammed paper.
You may get hurt.
This machine's power interception device is the power cord.
To switch off the power supply, remove the power cord from the
electrical outlet.
Installation / Moving
Warning
Do not place the machine in an area with dust, humidity or water leaks.
This could result in electric shock or fire.
Caution
When moving the machine, turn the
power off and disconnect all cords;
then lift the machine with at least two
people are required to lift printer.
The machine could fall, causing human injury or
machine damage.
Do not put a cover over the machine or place it in an airtight
location, such as a closet.
If the machine is not well-ventilated, this could result in fire.
Do not place the machine on an unstable
surface.
The machine could fall, causing human injury or
machine damage.
Make sure you plug the power cord into a grounded
electrical outlet.
Otherwise, this could result in electric shock or fire.
The machine should be connected to the power
level which is specified on the label.
If you are unsure and want to check the power
level you are using, contact the electrical utility
company.
Do not overload wall outlets and extension cords.
This can diminish performance, and could result in electric
shock or fire.
Use only No.26 AWG
[ a ]
or larger, telephone
line cord, if necessary.
Use the power cord supplied with your machine for safe
operation. If you are using a cord which is longer than 2
meters (79”) with a 140V machine, then the gauge should be