Dell 1135n Multifunction Mono Laser Printer - Manual (Page 90)

If you select Manual Feeder for Source from your software application, you need to press OK each time you
print a page and load only one type, size and weight of print media at a time in the manual tray.
To prevent paper jams, do not add paper while printing when there is still paper in the manual tray. This also
applies to other types of print media.
Print media should be loaded face up with the top edge going into the manual tray first and be placed in the
center of the tray.
Always load the specified print media only to avoid paper jams and print quality problems (See
Print media
specifications ).
Flatten any curl on postcards, envelopes, and labels before loading them into the manual tray.
1. Load the paper in the manual tray.
Do not force the paper beyond the surface with mark when loading.
When printing the special media, you must follow the loading guideline (See Printing on special
media ).
When papers overlap when printing using manual tray, open tray 1 and remove overlapping papers
then try printing again.
When paper does not feed well while printing, push the paper in manually until it starts feeding
automatically.
2. Squeeze the manual tray paper width guides and adjust them to the width of the paper. Do not force them
too much, or the paper will bent resulting in a paper jam or skew.
3. To print in application, open an application and start the print menu.
4. Open Printing Preferences (See Opening printing preferences ).
5. Press the Paper tab in Printing Preferences, and select an appropriate paper type.
For example, if you want to use a label, set the paper type to Label.
6. Select Manual Feeder in paper source, then press OK.
7. Start printing in application.
If you are printing multiple pages, load the next sheet after the first page prints out, and press the OK.
Repeat this step for every page to be printed.
Printing on special media
The table below shows the available special media for each tray.
When using special media, feed one paper at a time. Check the maximum input number of media for each tray
(See
Print media specifications ).
Types Tray 1 Manual tray
Plain ? ?
Thick ? ?
Thin ? ?
Bond ?
Color ?
CardStock ?
Labels ?