Dell PowerVault DR2000v User Manual
Page 152
Configuring DR Series System Information Using NetBackup
The topic introduces the concept of configuring the DR Series system information using the NetBackup media server
command line interface (CLI) commands and graphical user interface (GUI) menus, tabs, and options. The NetBackup
CLI commands and GUI menus, tabs, and options allow you to configure both the Linux or Windows media servers. In the
DR Series System Administrator Guide
documentation, you will find specific topics that address operations for using the
NetBackup CLI, such as adding the DR Series system name to NetBackup on each Linux and Windows media server you
intend to use with the DR Series system, using the NetBackup GUI to configure it to work with the DR Series system via
OST, using the NetBackup GUI to configure disk pools from logical storage units (LSUs) on the DR Series system, and
using the NetBackup GUI to create storage units using the disk pools on the DR Series system.
Related Links
Configuring NetBackup for the DR Series System
Configuring the DR Series System Using the Backup Exec GUI
Using NetBackup CLI to Add DR Series System Name (Windows)
Using NetBackup CLI to Add the DR Series System Name (Linux)
Using NetBackup CLI to Add DR Series System Name (Linux)
This topic describes how to use the NetBackup CLI to add the DR Series system name to each Linux-based media server
you plan to use with the DR Series system.
1.
Add the DR Series system name to NetBackup by using the following command:
/usr/openv/netbackup/bin/admincmd/nbdevconfig -creatests
-storage_server servername -stype DELL -media_server mediaservername
2.
Log in to and authenticate with DR Series system by using the following command (for details, see
).
/usr/openv/volmgr/bin/tpconfig -add -storage_server servername -stype DELL -
sts_user_id backup_user -password password
NOTE: On the DR Series system, only one user account exists, and the user ID for that account is
backup_user. You can only change the password for this account; you cannot create a new account nor can
the existing account be deleted.
Using NetBackup CLI to Add DR Series System Name (Windows)
This topic describes how to use the NetBackup CLI to add the DR Series system name to each Windows-based media
server you plan to use with the DR Series system.
1.
Add the DR Series system name to NetBackup by using the following command:
$INSTALL_PATH\VERITAS\NetBackup\bin\admincmd\nbdevconfig
-creatests -storage_server servername -stype DELL -media_server
mediaservername
2.
Log in to and add the valid credentials for authentication by the DR Series system by using the following command
$INSTALL_PATH\VERITAS\Volmgr\bin\tpconfig -add -storage_server servername -
stype DELL -sts_user_id backup_user -password password
152