Dell Vostro 1710 (Early 2008) - Manual (Page 38)

1 system board connector 2 M2 x 3-mm screws (2)
3 power button pad cable 4 power-button pad
5 multimedia panel
6 multimedia-button pad cable
7 palm rest
Replacing the Power Button and Multimedia Button Pads
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that
shipped with your computer.
NOTICE: The power button and multimedia button pads should be removed and reinstalled as a single unit.
This procedure assumes that you have completed the removal procedure Removing the Power Button and Multimedia Button
Pads .
1. Connect the power-button pad cable in the connector on the bottom of the multimedia button pad.
2. Replace the power button pad, positioning it under the tabs on the palm rest and aligning the screw hole.
3. Gently reinsert the multimedia-button pad cable underneath the palm rest.
4. Slide the multimedia button pad to the right, aligning it under the tabs on the palm rest and aligning the screw hole.
5. Replace the M2 x 3-mm screw that secures the power button pad to the palm rest.
6. Replace the M2 x 3-mm screw that secures the multimedia button pad to the palm rest.
7. Connect the multimedia-button pad cable to the connector on the system board.
8. Replace the keyboard (see Replacing the Keyboard ).
9. Replace the hinge cover (see Replacing the Hinge Cover ).
Back to Contents Page