Dell Vostro 1710 (Early 2008) - Manual (Page 44)

2. Disconnect the antenna from the WLAN card (see Removing a WLAN Card ).
3. Remove the hinge cover (see Removing the Hinge Cover ).
4. Remove the keyboard (see Removing the Keyboard ).
5. Remove the display assembly (see Removing the Display Assembly ).
6. Remove the display bezel (see Removing the Display Bezel ).
7. Remove the display panel (see Removing the Display Panel ).
8. Remove the two M2.5 x 5-mm screws from the hinges.
9. Remove the display panel (see Removing the Display Panel ).
10. Lift the display panel out of the top cover.
11. Disconnect the display cable from the connector on the back of the display panel.
12. Disconnect the display cable from the display inverter on the back of the display panel.
1 display panel 2 display cable connector
3 display cable
Replacing the Display Cable
CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your
computer.
This procedure assumes that you have completed the removal procedure Removing the Display Cable .
1. Connect the display cable to the display inverter on the back of the display panel.
2. Connect the display cable to the connector on the back of the display panel.
3. Align the guide pins at the top of the display hinge panels and position the display panel in the top cover.
4. Replace the two M2.5 x 5-mm screws in the hinges.
5. Replace the display panel (see Replacing the Display Panel ).
6. Replace the display bezel (see Replacing the Display Bezel ).
7. Replace the display assembly (see Replacing the Display Assembly ).