Dell Vostro 1710 (Early 2008) - Manual (Page 41)

9. Replace the hinge cover (see Replacing the Hinge Cover ).
10. Close the display and turn the computer upside down.
11. With the computer facing bottom side up, replace the screw located at the bottom of the battery bay near the edge of
the computer.
12. Replace the two M2.5 x 8-mm screws that attach the display assembly to both corners of the computer.
13. Reconnect the antenna to the WLAN card (see Replacing a WLAN Card ).
Display Bezel
Removing the Display Bezel
CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your
computer.
1. Follow the instructions in Before Working on Your Computer .
2. Disconnect the antenna from the WLAN card (see Removing a WLAN Card ).
3. Remove the hinge cover (see Removing the Hinge Cover ).
4. Remove the keyboard (see Removing the Keyboard ).
5. Remove the display assembly (see Removing the Display Assembly ).
6. Remove the eight rubber display-bumpers from around the display bezel.
7. Remove the four M2.5 x 5-mm screws and the four shoulder screws from around the display bezel.
1 M2.5 x 5-mm screws (4) 2 rubber display bumpers (8)
3 M2.5 x 5-mm shoulder screws (4) 4 display bezel
NOTICE: Removal of the bezel from the top cover requires extreme care to avoid damage to the bezel.
8. Starting at the middle bottom of the display panel, use your fingers to separate the bezel from the top cover, then lift
the inside edges to separate the remainder of the bezel.