Dell POWEREDGE M915 - Manual (Page 132)

132 About Your System
TPM configuration
operation is
pending.
Press (I) to
Ignore OR (M) to
Modify to allow
this change and
reset the system.
WARNING: Modifying
could prevent
security This message is displayed
when the system re-starts
after a TPM configuration
command is entered.
Enter I or M to proceed.
TPM configuration
operation honored.
System will now
reset TPM configuration
operation command has
been accepted
For information only.
Unsupported CPU
combination. Mismatched processors are
installed.
Processor is not supported
by the blade.
Replace a processor so that
both processors match. See
"Processors" on page 243.
Check for a BIOS update
using the Dell Support
website at support.dell.com.
Unsupported CPU
stepping detected. Processor is not supported
by the blade.
Check for a BIOS update
using the Dell Support
website at support.dell.com.
If the problem persists,
install a supported processor.
See "Processors" on
page 243.
CPU set to minimum
frequency. The processor speed may
be intentionally set low for
power conservation.
If not an intentional setting,
check any other system
messages for possible causes.
Table 1-27. Blade Messages (continued)
Message Causes Corrective Actions