Dell POWEREDGE M915 - Manual (Page 145)

Using the System Setup Program and UEFI Boot Manager 145
Internal SD Card Port
(PowerEdge M915,
M910, M905, M805,
M710, M710HD, M610
and M610x)
Enables or disables the system’s internal SD card port.
NOTE: If a hypervisor is installed, it uses this port.
Redundancy
(Disabled default)
(M915, M910 and
M710HD)
Enables or disables the mirror mode for Internal Dual SD
Module (IDSDM).
NOTE: When set to Mirror Mode, the vFlash functionality of
the iDRAC 6 card is not available and the card is set as the
secondary SD card (SD2) in IDSDM.
Embedded NICn and
NICn
Enables or disables integrated NIC1 and NIC2. Changes
take effect after the system reboots.
Embedded Gb NICx
(Enabled with PXE
default)
Enables or disables the system's integrated Gb NICs.
Options are Enabled, Enabled with PXE, Enabled with
iSCSI Boot, and Disabled. PXE support allows the system
to boot from the network. Changes take effect after the
system reboots.
Embedded NIC1 and
NIC2
(Enabled default)
Enables or disables the system's embedded NIC1 and NIC2
controller.
NOTE: For M710HD, you can enable or disable the NIC1/NIC2
and NIC3/NIC4 controllers.
MAC Address Displays the MAC address for a particular integrated NIC.
This field does not have user-selectable settings.
iSCSI MAC Address Displays the iSCSI MAC address for a particular integrated
NIC if Enabled with iSCSI Boot is enabled. This field
does not have user-selectable settings.
Capability Detected Displays the features provided by the hardware key
installed in the NIC hardware key socket on the system
board.
NOTE: Some features may require the installation of an
additional driver.
Option Description