Replacing the front bezel – Dell Alienware Aurora R3 (Early 2011) User Manual
Page 15
Replacing the Front Bezel
1.
Follow the instructions in
Before You Begin
.
2.
Align the front bezel with the front of the chassis.
3.
Replace the three screws on the right side that secure the front bezel to the chassis.
4.
Lay the chassis on its side.
5.
Route and connect the front-bezel cables to the connectors on the master I/O board.
6.
Replace the seven screws that secure the front bezel to the chassis.
7.
Replace the right-side bottom panel (see
Replacing the Right-Side Bottom Panel
).
8.
Replace the right-side middle panel (see
Replacing the Right-Side Middle Panel
).
9.
Replace the lighting board (see
Replacing the Lighting Board
).
10.
Replace the right-side top panel (see
Replacing the Right-Side Top Panel
).
11.
Replace the drive-bay shroud (see
Replacing the Drive-Bay Shroud
).
12.
Close the PCI shroud (see
Closing the PCI Shroud
).
13.
Replace the left side-panel (see
Replacing the Left Side-Panel
).
14.
Connect your computer and all attached devices to electrical outlets, and turn them on.
Back to Contents Page
1
front bezel
2
screws (3)
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.