Dell XPS 600 User Manual

Page 115

Advertising
background image

Removing and Installing Parts

115

5 Remove the heat sink:

NOTICE:

After the heat sink has been removed, lay the heat sink down on its side to avoid damaging the

thermal interface on the bottom.

a

Remove the retention module clip from the side of the retention base opposite the power
supply. Pull the tab on the clip straight out and away from the retention base to remove it.

b

On the retention base locate the
retention tab on the side opposite
the power supply, then press on
the tab, away from the heat sink
until the heat sink pops up
slightly.

c

Rotate the heat sink back, then
slide it forward from beneath the
second retention tab and lift it
out of the retention base.

d

Remove the remaining retention
module clip, as needed.

NOTE:

Removal of the remaining

retention module clip is not
necessary for removal of the
processor.

retention
module clips

Advertising