Dell XPS 600 User Manual

Page 25

Advertising
background image

Setting Up and Using Your Computer

25

Create a RAID level 0 volume or RAID level 1 volume only when you are adding two new drives
to an existing single-drive computer configured as a single-drive level 0 RAID array, and you
want to configure the two new drives into a RAID array.

Although any size drives may be used to create a RAID configuration using Nvidia MediaShield,
ideally the drives should be of equal size. In a RAID level 0 configuration, the size of the
configuration will be the size of the smallest drive multiplied by the number (two) of drives in
the configuration. In a RAID level 1 configuration, the size of the configuration will be the
smaller of the two drives used.

Creating a RAID Array

NOTICE:

You will lose any data on your hard drives when you create a RAID configuration using the

following procedure. Back up data you want to keep before continuing.

NOTE:

Do not use the following procedure to migrate an existing storage configuration to RAID level 0

configuration.

1 Enable RAID on your hard drives (see "Setting Your Hard Drives to RAID-Enabled Mode" on

page 23).

2 After rebooting your computer, launch Nvidia MediaShield.
3 Click Create Array in the System Tasks pane.

The Create Array Wizard appears.

4 Use the drop-down box to select Striping (for RAID 0) or Mirroring (for RAID 1).
5 Click Next.
6 Click to select the drives that will make up the RAID configuration.

NOTE:

Your computer supports a maximum of two drives per RAID1 array and three per RAID0

array.

7 Select desired options.

NOTICE:

The

Clear System Data option will delete all data on the selected drive.

8 Click Next.
9 Click Finish to create the RAID configuration.

The array and any other installed hard drives should be visible in the NVRAID management
utility window.

Deleting a RAID Array

NOTE:

While this procedure deletes the RAID 1 volume, it also splits the RAID 1 volume into two non-

RAID hard drives with a partition, and leaves any existing data files intact. Deleting a RAID 0 volume,
however, destroys all data on the volume.

Advertising