Dell XPS 600 User Manual
Page 99
Removing and Installing Parts
99
7 If you are adding a second hard drive, remove the first hard drive from the upper bay and
install it in the lower bay:
a
Disconnect the power and the hard-drive cables from the back of the first hard drive.
b
Press in the two rail tabs and pull the first hard drive out of the upper bay.
c
Gently slide the first hard drive into the lower bay until it clicks into place.
d
Reconnect the power and hard-drive cables to the back of the first hard drive.
8 Install the hard drive into the computer by gently sliding the drive into place until the tabs
securely click into position.
NOTE:
If you are installing a hard drive in the lower bay, place the drive in the bay so that the power
connector is on the left-hand side (opposite of the top hard drive)
drive
screws (4)
bracket rails (2)
hard drive
hard-drive cable
power cable
tabs (2)
system board connector