Dell Latitude 12 Rugged Extreme (7204, Early 2014) - Manual (Page 16)

Installing the USH Board
1. Connect the smart card cable to the USH board at the bottom of the board.
2. Flip the USH board to replace it to its original position.
3. Tighten the screws to secure the USH board.
4. Connect the cables to the USH board.
5. Install:
a. bottom cover
b. battery
6. Follow the procedures in After Working Inside Your computer .
Removing the Docking Board
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove:
a. battery
b. bottom cover
3. To release the docking board:
a. Disconnect the antenna cables from the docking board [1].
CAUTION: Exercise caution while disconnecting the antenna cables. Improper removal
may result in damage/breakage of the antenna cables.
b. Remove the screws that secure the docking board [2].
16