Dell Latitude 12 Rugged Extreme (7204, Early 2014) - Manual (Page 36)

d. heatsink
e. WWAN
f. WLAN
g. antenna routing bracket
h. memory
i. card bracket
j. system fan
k. Connect the battery cable to the battery board.
l.
hard drive
m. MEMS board
n. USH board
o. GPS module
p. docking board
q. bottom cover
r. battery
5. Follow the procedures in After Working Inside Your computer .
Removing the Display Assembly
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove:
a. battery
b. bottom cover
c. docking board
d. GPS module
e. USH board
f. MEMS board
g. hard drive
h. Disconnect the battery cable to from the battery board.
i.
card bracket
j. WLAN
k. WWAN
l. heatsink
3. To remove the eDP connector and unroute the display cables:
a. Unroute the display cable from the system board [1].
b. Remove the screws that secure the eDP connector [2].
c. Lift up and remove the bracket from the connector [3].
36