Dell Latitude 12 Rugged Extreme (7204, Early 2014) - Manual (Page 34)

Installing the Power Connector
1. Insert the power connector by aligning it with the connector side with the base of the computer
chassis.
2. Press to firmly secure the power connector to the computer chassis.
3. Install:
a. system board
b. SIM board
c. battery board
d. heatsink
e. WWAN
f. WLAN
g. antenna routing bracket
h. memory
i. card bracket
j. system fan
k. Connect the battery cable to the battery board.
l.
hard drive
m. MEMS board
n. USH board
o. GPS module
p. docking board
q. bottom cover
r. battery
4. Follow the procedures in After Working Inside Your computer .
Removing the Palmrest
1. Follow the procedures in Before Working Inside Your Computer
2. Remove:
a. battery
b. bottom cover
c. docking board
d. GPS module
e. USH board
f. MEMS board
g. hard drive
h. Disconnect the battery cable from the battery board.
i.
system fan
j. card bracket
k. memory module
l. antenna routing bracket
m. WLAN
n. WWAN
o. heatsink
p. battery board
q. SIM board
34