Dell KVM 1082DS - Manual (Page 128)

118 xxx | LDAP Feature for the RCS xxx
Standard LDAP Message Port via SSL - 636
Active Directory via Global Catalog server - 3268
Active Directory via Global Catalog server/SSL - 3269
IP Port numbers are permitted to range from 1 to 65535. Failure to match up
port numbers with those in use by the LDAP Directory Server will result in a
failure to establish communications with that server.
Completing LDAP Configuration
For both Standard and Active Directory LDAP modes, additional parameters are
required to insure proper connectivity to the LDAP Directory Servers. These
parameters are discussed in the following sections. However, you should be aware
that there are 'interlocks' established in the OBWI pages to assist the
administrator by insuring that parameter updates are made on the appropriate
page.
For example, if you were to select the Active Directory LDAP tab, you might
see the following display on your screen see Figure 5.4
Figure 5.4: Notification Message - LDAP Mode Not Enabled
When this happens, it is an indication that the Active Directory mode has not
been enabled or it was enabled, but not saved. You should return to the LDAP
Options screen, select Active Directory LDAP, make note of the secondary
parameters for this mode on that page, then click Save before returning to this
screen.