0uconfiguration – Dell KVM 1082DS User Manual
Page 34
Advertising
24
xxx
|
Installation
xxx
2
Rotate each rail 180° (item 2) and then reassemble each rail to the switch
(item 3).
3
Refer to the 1U rear-rack instructions to insert and remove the switch
assembly from the ReadyRails system.
NOTE: No blanking panel is required for this configuration.
0U RCS Installation
1
Align and assemble the 0U mounting bracket to the switch rails (Figure 2.7,
item 1). Tighten the thumbscrews (item 2).
2
Insert the mounting bracket hooks into the rack holes and push down until
the blue button pops out and locks the bracket into place.
Figure 2.7: 0U Installation
Advertising