Dell KVM 1082DS - Manual (Page 44)

34 xxx | Installation xxx
Cascading with Legacy Switches
To add a legacy switch (optional):
1 Mount the switch into your rack. Locate a UTP cable to connect your RCS
to the legacy switch.
2 Attach one end of the UTP cabling to the ARI port on the Console Switch.
3 Connect the other end of the UTP cable to a PS/2 SIP.
4 Connect the SIP to your legacy switch according to the switch
manufacturer's recommendations.
5 Repeat steps 1-4 for all the legacy switches you wish to attach to your
switch.
NOTE: The RCS supports only one switch per ARI port. You cannot cascade
another switch under this first switch.
NOTE: When cascading with an RCS, an 8-port or 16-port analog console
switch is not supported as the primary unit. The RCS must be the primary unit.