Dell KVM 1082DS - Manual (Page 51)

Installation xxx | xxx 41
For information on launching the OBWI, see "OBWI" on page 45.
Verifying the Connections
Rear Panel Ethernet Connection LEDs
On the RCS, the rear panel features two LEDs indicating the Ethernet LAN1
connection status and two LEDs indicating the Ethernet LAN2 connection
status.
• The green LEDs illuminate when a valid connection to the network is
established and blink when there is activity on the port.
• The bi-color LEDs may illuminate either green or amber.
• They illuminate green when the communication speed is 1000M.
• They illuminate amber when the communication speed is 100M.
• They are not illuminated when the communication speed is 10M.
Rear Panel Power Status LEDs
The rear panel of each RCS has one for each power supply. There are two Power
LEDs for dual power models (16-port and 32-port) and only one LED for the 8-
port model. The LED(s) illuminate green when the switch is turned on and
operating normally.
• The LED is off if the power supply does not have power or has failed.
• The LED illuminates when the unit is ready.
• The LED blinks when the switch is booting or an upgrade is in progress.
• The LED blinks "SOS" if a fault condition occurs, such as power supply
failure, elevated ambient temperature, or fan failure. The LED will continue
to blink "SOS" as long as the failure persists.
The switch prevents a serial break from the attached device if the module loses
power. However, a user can generate a serial break with the attached device by
pressing Serial Break on the serial session viewer.