Dell KVM 1082DS - Manual (Page 169)

C
Appendix C: MIB and SNMP Traps xxx | xxx 159
Appendix C: MIB and SNMP
Traps
The Dell RCS has the ability to send audit events to an SNMP Manager. The
SNMP traps are defined in an SNMP Trap MIB.
The Trap MIB file may be uploaded from the RCS using the Save Trap MIB
function. The uploaded Trap MIB file may then be loaded into an SNMP Trap
Receiver application.
Audit events may also be directed to “syslog” destinations. The format of each
syslog message is given in the corresponding “--#SUMMARY” comment of each
trap defined in the Trap MIB file.
This appendix describes the trap events which the RCS may generate. Although
care has been taken to keep the information in this appendix up to date, the
Trap MIB file will contain the most accurate trap information.
An SNMP manager may access MIB-II objects of the RCS using the IPv4 or
IPv6 protocols.
By design, the enterprise specific MIB objects within the RCS cannot be
accessed using SNMP.
The RCS Trap definitions use the structure described in the following Request
For Comments (RFCs).
• RFC-1155-SMI
Describes the common structures and identification scheme for the
definition of management information for use with TCP/IP-based
Internets.