Dell Inspiron 531s (Mid 2007) - Manual (Page 116)

116
Removing and Installing Parts
1 Follow the procedures in "Before You Begin" on page 101.
2 Press out the securing clip at each end of the memory module connector.
3 Grasp the module at the end of the board and lift up.
4 Replace the PCI Express x16 card (see "Cards" on page 116).
Cards
CAUTION:
Before you begin any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
NOTICE:
To prevent static damage to components inside your computer, discharge
static electricity from your body before you touch any of your computer’s electronic
components. You can do so by touching an unpainted metal surface on the
computer chassis.Your Dell™ computer provides the following slots for PCI and
PCI Express cards:
• One PCI Express x16 card slot (SLOT1)
• One PCI Express x1 card slot (SLOT2)
• Two PCI card slots (SLOT3, SLOT4)
See "System Board Components" on page 107 for card slot location.
PCI and PCI Express Cards
Your computer supports two PCI cards, one PCI Express x16 card and one
PCI Express x1 card.
• If you are installing or replacing a card, follow the procedures in the next section.
• If you are removing but not replacing a card, see "Removing a PCI/PCI
Express Card" on page 121.
• If you are replacing a card, remove the current driver for the card from the
operating system.
book.book Page 116 Wednesday, April 16, 2008 3:33 PM