Dell Inspiron 531s (Mid 2007) - Manual (Page 36)

36
Setting Up and Using Your Computer
NOTICE:
The graphics card in your computer is installed in the PCI Express x16 slot.
When there is a card in this slot and you add a peripheral that does not support s3
suspend, your computer will not enter standby mode.
To set standby mode to automatically activate after a defined period of
inactivity:
1 Click the Start button, then click Control Panel.
2 Define your standby settings on the Power Schemes Tab and
Advanced Tab.
To immediately activate standby mode without a period of inactivity, click the
Start button, click Turn Off Computer, and then click Stand by.
To exit from standby mode, press a key on the keyboard or move the mouse.
Hibernate Mode
Hibernate mode conserves power by copying system data to a reserved area on
the hard drive, and then completely turning off the computer. When the
computer exits from hibernate mode, the desktop is restored to the state it
was in prior to entering hibernate mode.
To activate hibernate mode:
1 Click Start→ Control Panel→ Pick a category→ Performance and
Maintenance.
2 Under or pick a Control Panel icon, click Power Options.
3 Define your hibernate settings on the Power Schemes tab, Advanced tab,
and Hibernate tab.
To exit from hibernate mode, press the power button. The computer may
take a short time to exit from hibernate mode. Because the keyboard and
mouse do not function in hibernate mode, pressing a key on the keyboard or
moving the mouse does not bring the computer out of hibernation.
Because hibernate mode requires a special file on your hard drive with enough
disk space to store the contents of the computer memory, Dell creates an
appropriately sized hibernate mode file before shipping the computer to you.
If the computer’s hard drive becomes corrupted, Windows XP recreates the
hibernate file automatically.
book.book Page 36 Wednesday, April 16, 2008 3:33 PM