Beep codes – Dell Inspiron 531s (Mid 2007) User Manual
Page 80
80
Troubleshooting Tools
•
If the power light is blinking amber, the computer is receiving electrical
power, a device might be malfunctioning or incorrectly installed.
–
Remove and then reinstall the memory modules (see "Memory" on
page 112).
–
Remove and then reinstall any cards (see "Cards" on page 116).
–
Remove and then reinstall the graphics card, if applicable (see "Cards"
on page 116).
•
If the power light is steady amber, there may be a power problem or an
internal device malfunction.
–
Ensure that all power cables are securely connected to the system
board (see "System Board Components" on page 107).
–
Ensure that the main power cable and front panel cable are securely
connected to the system board (see "System Board Components" on
page 107).
Beep Codes
Your computer might emit a series of beeps during start-up if the monitor
cannot display errors or problems. This series of beeps, called a beep code,
identifies a problem. One possible beep code consists of repetitive three short
beeps. This beep code tells you that the computer encountered a possible
motherboard failure.
If your computer beeps during start-up:
1 Write down the beep code.
2 Run the Dell Diagnostics to identify a more serious cause (see "Dell
Code
(repetitive short
beeps)
Description
Suggested Remedy
3
Possible motherboard
failure.
Contact Dell.
1
BIOS checksum
failure. Possible
motherboard failure.
Contact Dell.
book.book Page 80 Wednesday, April 16, 2008 3:33 PM